hello
have problem with power to ms.
the battery lamp in megatune is showing, battery low,than ok,than low,than ok.......
have check all of the things in troubleshooting your megasquirt - v3 main board.
i was woundering if any have hade the same problem
alllfai
-NORWAY-
trouble with ms2 v3 power
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: trouble with ms2 v3 power
alllfai,
What processor and code are you running? If this is V2.88+, then you might need to set the ECU type.
Post a datalog and your MSQ and we can have a look.
Lance.
What processor and code are you running? If this is V2.88+, then you might need to set the ECU type.
Post a datalog and your MSQ and we can have a look.
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw