Powering WBO2 and KnocksenseMS on Relay Board?

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
GGR
MegaSquirt Newbie
Posts: 20
Joined: Tue Nov 03, 2009 11:15 am

Powering WBO2 and KnocksenseMS on Relay Board?

Post by GGR »

Hi all,

For convenience and centralizing purposes I would like to power my WBO2 sensor and knocksenseMS on the Relay board unless it is not adviseable.

If OK, can I connect their power supply together with the fuel pump power supply on the relay board? What about getting the power from one of the pins on the JP2 block (powering the injectors)? I'm using only two of the pins for the injectors so I have two that I'm not using.

Thanks in advance!
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: Powering WBO2 and KnocksenseMS on Relay Board?

Post by Matt Cramer »

The injector power outputs should be OK to use.
Top
GGR
MegaSquirt Newbie
Posts: 20
Joined: Tue Nov 03, 2009 11:15 am

Re: Powering WBO2 and KnocksenseMS on Relay Board?

Post by GGR »

Thanks!
Top
Post Reply

Return to “Wiring and Sensors”