I have looked this forum over for somthing similar to my problem but have not really found much information that helps me out. My injectors will not fire, they have 12v and are known good injectors, i can trace the power from the main relay to the injectors then out and all the way to the plug on the MS, so all the wiring is good but the MS is not pulling the injectors to ground to fire them. I dont have a stim so i dont know what to do that will help me with finding my problem. I have taken the MS apart and examined it but can see no tell tail markings of anything being bad. and pointers or information would be greatly appreciated. I think a stim is in my furture however.
Thanks, Jake.
injector troubles
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: injector troubles
its an MSII, I dont remember the Code but i do belive its the newest one forgot to mention that before.
-
kjones6039
- Master Squirter
- Posts: 618
- Joined: Sat Jul 22, 2006 7:02 pm
- Location: Eureka, Nevada USA
- Contact:
Re: injector troubles
Would be a very good choice!I think a stim is in my furture however.
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
Re: injector troubles
Got it fixed and running, made a stupid mistake in the begining and had ECM stting in general setup to microsquirt not MSII and i didnt catch it untill right now. But now thats changed and its working great.