Hi, and thanks in advance for any help. I am assembling a MS2 V3. Have checked and double checked the power supply per the instructions, all OK. Completed loopback test of the RS232 comm link, all OK.
Using Download 2.00 to load Monitor_v2.905.abs.s19.
I get the following output (verbosity setting increased to 3):
Reading C:/My Documents/Monitor_v2.905.abs.s19:
Detected MS-II (HCS12) code.
Entry point: 0x0000
Code range : 0x4000-0x3db360
File read successfully.
Opened comm port 1 at 115200.
Monitor mode failed.
Erasing main FLASH:
ERROR: Command not recognized, e=0xE1
Elapsed time: 0.54 seconds
MegaSquirt Download 2.00
Reading C:/My Documents/Monitor_v2.905.abs.s19:
Detected MS-II (HCS12) code.
Entry point: 0x0000
Code range : 0x4000-0x3db360
File read successfully.
Opened comm port 1 at 115200.
Erasing main FLASH:
Erased.
Writing:
ERROR: Timed out reading response, 0xE0
Elapsed time: 3.05 seconds
I've double checked solder joints, as this was the fix for a prior poster. No luck. Any ideas?
Thanks again.
Error during bootload
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Error during bootload
Problem solved. Switched from an old win98 laptop (direct RS232) to a new laptop (USB converter) and everything worked on 1st try. Sorry to waste bandwidth.