Hello
is there a maunal for Tunerstudio? there are way more functions than the megatune using a MS1 V2.2, why is there not a manual to figure out all the aspects of this?
Anything other than pushing F1-very vague
manual
Moderator: LT401Vette
-
vwsuperbug
- MegaSquirt Newbie
- Posts: 9
- Joined: Wed Feb 09, 2011 6:17 pm
manual
You do not have the required permissions to view the files attached to this post.
-
LT401Vette
- Master Squirter
- Posts: 481
- Joined: Sat Jul 16, 2005 7:07 am
- Location: Charlotte, NC
- Contact:
Re: manual
You have you TunerStudio set up to use MS1Extra, so you will need to use the MS1Extra manual and should go to the msextra.com forum.
http://www.msextra.com/doc/index.html#ms1
Unless your project is setup for MS1Extra by mistake?
Did you actually install MS1Extra firmware on your MegaSquirt?
If you intend to use only the MS1 B&G code, then go into TunerStudio Project Properties and change the ECU Definition file to:
megasquirt-I_B&G_2.0-3.0
Then you will have basically the same menus and dialogs as MegaTune.
http://www.msextra.com/doc/index.html#ms1
Unless your project is setup for MS1Extra by mistake?
Did you actually install MS1Extra firmware on your MegaSquirt?
If you intend to use only the MS1 B&G code, then go into TunerStudio Project Properties and change the ECU Definition file to:
megasquirt-I_B&G_2.0-3.0
Then you will have basically the same menus and dialogs as MegaTune.
Phil Tobin
EFI Analytics, helping to simplify EFI with Next Generation tuning software.
http://www.tunerstudio.com/
http://www.efiAnalytics.com/MegaLogViewer/
Android Shadow Dash MS: http://tunerstudio.com/index.php/shadowdashmsmenu
EFI Analytics, helping to simplify EFI with Next Generation tuning software.
http://www.tunerstudio.com/
http://www.efiAnalytics.com/MegaLogViewer/
Android Shadow Dash MS: http://tunerstudio.com/index.php/shadowdashmsmenu