Hooking up Megasquirt 2 to a Crane Hi-6
Posted: Tue Sep 03, 2013 5:11 pm
I am installing a Megasquirt 2 (PCB 3) in my '79 mustang. Previously I installed a Ford mass air EEC from a '90. I have a Crane Hi-6 in the car that I would like to continue to use.
In order to have the factory tach work I had to install a tach adapter (Crane #6000-8910). Here is a link to the instructions;
http://www.cranecams.com/uploads/instru ... -8910_.pdf
In the instructions is says that "The tach adapter simulates
the action of the coil and generates a high voltage pulse
whenever the OE module triggers."
I had no problems with it working with the Ford A9l computer. Will this high voltage pulse be a problem for the MS2? Thanks.
Jess
I
In order to have the factory tach work I had to install a tach adapter (Crane #6000-8910). Here is a link to the instructions;
http://www.cranecams.com/uploads/instru ... -8910_.pdf
In the instructions is says that "The tach adapter simulates
the action of the coil and generates a high voltage pulse
whenever the OE module triggers."
I had no problems with it working with the Ford A9l computer. Will this high voltage pulse be a problem for the MS2? Thanks.
Jess
I