hei distributor

This forum is for discussing ignition setup, tuning, and troubleshooting for MS-II. Click these links for info on GM's HEI, EDIS, direct coil control, others.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
84tpivette
MegaSquirt Newbie
Posts: 14
Joined: Sat Nov 09, 2013 10:14 pm

hei distributor

Post by 84tpivette »

Possible to use the vr sensor In the stock distributor to fire the stock coil in cap? I have a 7 pin and 4 pin distributors. How would one wire the ms2 v3.0 board
1984 Corvette TPI(no longer cease fire) ms2 v3 in the works
Top
DonTZ125
Experienced Squirter
Posts: 337
Joined: Sat May 16, 2009 1:49 pm
Location: Scarborough, ON
Contact:
Contact DonTZ125

Re: hei distributor

Post by DonTZ125 »

This is covered in loving detail in the HEI section of the manual. :RTFM:
Top
Post Reply

Return to “MS-II Ignition Setup, Tuning, and Troubleshooting”