I have problems building up my Ms2 V3.0 on step 55, where I need to check the input section. The problem is that I lost the connection to my PC. I pass the connection test at step 41. There is IGN led light up on STIM, but nothing else no weird noises nothing. I tried to use portCheck,tunerstudio port checks and even msdownloader to check port settings but every attempt goes dead end. I used the hyperterminal to check the cable and this passes the loop back test, so I assume that the cable is fine and the problem is in board. I triple check every assambly step and can't find problems there. One of problems is that my native language is not English, so maybe I just reading it wrong.
-There is some things that i find out I had installed the D1 diode, now I jupmered it.
-I had problems with assembly step 41 and I started to measure voltages and resistances and I remember measuring less than 1ohms resistance on pins from MAX323 and CPU socket pins, but now I get 1.2 ohms there. The problem were there that I didn't have code loaded into the processor, when I loaded that, everything came alive(bad reading as I said)!
Any ideas what went wrong in those 10 steps?
Maybe I burned the board somewhere? I had problems soldering U2 MAP sensor, I soldered it backwards(but didn't powered up the board). I find my mistake immediately and started to resoldering the MAP sensor and it was really painful to solder it out and put in the right orientation, so a lot of heat in that location.
I post a picture with my board. So maybe you can find mistake just looking at pictures.
Hope for your help
Thank you in advance.
Sorry about my bad writing!
Here is the pic. of code loaded.
