Connector for 3 pads ??? (12v switch, 12v main and ground)

[Mueller]

I don't like the idea of soldering wires directly to the board on the 3 round pads for power and ground.

Is there a connector that I can solder that will allow me to use a crimped terminal wire to the board, I thought about soldering a stud on each pad, but the torque of tightening or removing a terminal might be too much.

Thanks

[Overkill]

I ended up soldering three short leads to it and put a weatherpack connector on it so that I could disconnect it from the car without to much trouble if I needed to.