MSefi.com read only forum (Jan.15,2018)

Within the EDIS setup manual in the MEgamanual it describes the settings for dwell times. I remember it being something like 5 M/s or 50% or something for Fixed dwell. I dont think you have to fiddle with that stuff;

Okay, thanks!

is there a way to test if the grounding point I have it attached to Is conductive enough...?
ohm reading between block and that point on chassis?

does it matter where the capacitor is grounded in relationship to the megasquirt grounds?

According to the Diagram Wires PIP and SAW wires are shielded , as well as as VR sensor Wires. then the shielding of both connects to Pin 7 of the EDIS Module. Is that correct?

In my wiring I have the Shielding of the VR sensor grounded on the Block, and the PIP is shielded only and it is grounded ...

What is the voltage needed for the capacitor?