i want to first thank Matt Cramer hes been very helpful.
question i am having is on the TFI ignition page i am going threw the steps to get the v3 main board ready for the TFI setup and i am at this step...
V3.0 main board:
* Use the Hall/optical/points input circuit, in step #50 of the V3 assembly guide, but:
o Use a 1k resistor in series with the ignition input coming from the TFI. Do this by pacing a 1K Ohm resistor in the main board location marked "D2" (instead of the jumper you would normally put there), and
what watt is this 1k resistor?
thanks
Ford TFI
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Ford TFI
Can't go wrong with 1/4 watt; that's what we typically use.
-
thecrew2999
- MegaSquirt Newbie
- Posts: 32
- Joined: Thu Aug 13, 2009 4:26 pm
Re: Ford TFI
thanks again