MAP Only on 'A' Series Engine

For discussing B&G MS-I/MS-II set-up and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
jb007
MegaSquirt Newbie
Posts: 14
Joined: Sun Oct 19, 2008 7:10 pm
Location: Hoppers Crossing, Victoria, Australia
Contact:
Contact jb007

MAP Only on 'A' Series Engine

Post by jb007 »

Hi all, my first post, so please be kind. :oops: Currently gathering all bit's & pieces to EFI my 1968 Morris Mini 1310 A series. I will be using MSII v3.0, a single injector in a TBI (wet manifold) configuration, running a standard mild cam. Can I get away with running MAP only, or do I have to use TPS as well? If I can do MAP only, where in Tunerstudio do you setup for this, or where can doco be found for this? :roll:

Thanks in advance.

Jim
Australian 1968 Morris Mini Deluxe 1310 A+ with Patton Machine Products HIF44 SU TBI Adapter
MegaSquirt III
My Blog: http://www.jims-blog.com
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: MAP Only on 'A' Series Engine

Post by Matt Cramer »

MAP-only should be fine. Just specify MAPdot acceleration enrichment in Acceleration Wizard and ground the TPS wire so as not to trigger flood clear mode.
Top
jb007
MegaSquirt Newbie
Posts: 14
Joined: Sun Oct 19, 2008 7:10 pm
Location: Hoppers Crossing, Victoria, Australia
Contact:
Contact jb007

Re: MAP Only on 'A' Series Engine

Post by jb007 »

Matt Cramer wrote:MAP-only should be fine. Just specify MAPdot acceleration enrichment in Acceleration Wizard and ground the TPS wire so as not to trigger flood clear mode.
Thanks for the info Matt. :)
Australian 1968 Morris Mini Deluxe 1310 A+ with Patton Machine Products HIF44 SU TBI Adapter
MegaSquirt III
My Blog: http://www.jims-blog.com
Top
Post Reply

Return to “Tuning Fuel and Air”