Bluetooth setting.

[devastator]

I've had exactly the same adapter that is for sale on your site, for a few years now.
Could you tell me what settings are needed to hook it to my MS2? I don't think my MS2 is wired as shown in the MegaManual, under Bluetooth, however.
Do I need a special cable, or just a gender changer? Do I need to take apart my MS2 and add the jumper wires shown in the MegaManual?

[LT401Vette]

It may look the same and not actually be the same, but if it is...
The ATI1 command should show these settings:

Code: Select all

ATC=0, NONE FLOW CONTROL
ATD=0000-00-000000, NEVER SET BLUETOOTH ADDRESS
ATE=0, NEVER ECHO CHARACTERS
ATG=1, ENABLE ALL PAGE AND INQUIRY SCAN
ATH=1, DISCOVERABLE
ATK=0, ONE STOP BIT
ATL=5, BAUD RATE is 115200
ATM=0, NONE PARITY_BIT
ATN=EFI Analytics 06, LOCAL NAME
ATO=0, ENABLE  AUTO CONNECTING
ATP=1234, PIN CODE
ATQ=0, SEND RESULT CODE
ATR=1, SPP SLAVE ROLE
ATS=1, ENABLE AUTO-POWERDOWN OF RS232 DRIVER
ATX=0, NEVER CHECK '+++'

from default settings enter:
atx0
atc0
ate0
atl5

Then you do need a gender changer if yours didn't come with one. It is best to not use a null modem gender changer as that often doesn't pass through PIN 9 power. The switch on it will allow you to use either gender changer though.

[devastator]

Thank you.
Do I need to make a cable to tie the send and receive lines together from my MS2 if I don't have jumpers soldered in place already?

[LT401Vette]

Do I need to make a cable to tie the send and receive lines together from my MS2 if I don't have jumpers soldered in place already?

Nope, it is set up to not need the hand shake.

[devastator]

Thanks Phil.
One last question, (hopefully).
I can't use a gender changer directly to my Ms2. Due to it's location, I must use a short cable of some sort. Can i use a standard cable with a gender changer on the end of it?
Does the TxD pin from my BT connect to the RxD pin on the MS, and vise-versa?

[LT401Vette]

No problem using a cable. Even if your RxD and TxD get reversed with a null modem, you can flip the switch on it and that will reverse the RxD and TdX on the BT Adapter.