Hi,
I bought second hand Innovate LC-1. Serial cable was missing from package. Can somebody tell how signals are connected between D9 and 2.5mm plug?
Innovate LC-1 serial cable pinout?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Innovate LC-1 serial cable pinout?
I found answer from Innovate forum:
'Using TRS (Tip Ring Sleeve) terminology:
the sleeve is the ground reference (DB-9 pin 5, and the connector shell);
the ring the serial OUT signal (DB-9 pin 2;
and the tip the serial IN signal (DB-9 pin 3);
I tested the factory cable and found no jumped pins on the DB-9 end (sometimes RTS/CTS and/or DSR/DTR are jumpered).'
http://www.innovatemotorsports.com/foru ... php?t=9926
More info:
http://www.innovatemotorsports.com/foru ... hp?t=10522
'Using TRS (Tip Ring Sleeve) terminology:
the sleeve is the ground reference (DB-9 pin 5, and the connector shell);
the ring the serial OUT signal (DB-9 pin 2;
and the tip the serial IN signal (DB-9 pin 3);
I tested the factory cable and found no jumped pins on the DB-9 end (sometimes RTS/CTS and/or DSR/DTR are jumpered).'
http://www.innovatemotorsports.com/foru ... php?t=9926
More info:
http://www.innovatemotorsports.com/foru ... hp?t=10522