RPM doesn't work when testing.

jet47 · Post by **jet47** » Thu Mar 31, 2011 5:44 am

All sensors other than tach work fine when testing.

I have tried all 3 tach circuits, with jumpers in correct positions for each and get no signal on megatune.

I'm leaning toward the stim not putting a signal out.

Has anyone seen this?

I get 3000 rpm briefly when I connect the stim to ms, but nothing afterwards.

ms1v3

jet47 · Post by **jet47** » Thu Mar 31, 2011 6:06 am

Sorry, I posted this in the wrong section, feel free to remove it.

8974Ollie · Post by **8974Ollie** » Thu Mar 31, 2011 6:45 am

There will not be an RPM signal unless MegaSquirt is connected to a running engine.

jet47 · Post by **jet47** » Thu Mar 31, 2011 6:50 am

Thanks for the reply.

Will you explain this a ittle more, why is there an rpm pot on the stimulator?

8974Ollie · Post by **8974Ollie** » Sat Apr 02, 2011 6:14 am

Turning the RPM pot knob will move the RPM gauge needle, to test the circuit. As for a specific RPM, No

jet47 · Post by **jet47** » Sun Apr 03, 2011 8:49 am

So in Megatune turning the rpm pot should generate a signal like the other pots?

I was able to hook the computer to my vehicle and the computer is working.
I may have damaged something on the stimulator while building it.

Thanks for the help.

MSefi.com read only forum (Jan.15,2018)

RPM doesn't work when testing.

RPM doesn't work when testing.

Re: RPM doesn't work when testing.

Re: RPM doesn't work when testing.

Re: RPM doesn't work when testing.

Re: RPM doesn't work when testing.

Re: RPM doesn't work when testing.